General Double beam crane
Post Message
-
General Double beam crane
-
2016-04-13
-
Machinery, Mold & Fastener
-
Machining - relative Selling Leads or Buying Leads
-
China
-
Offer to sell
-
Product introduction
The double-beam crane main beam by a wide variety of steel welded, the structure is very complex. There are some problems that cause main beam deformation, such as the thin structure, needs to be improved. This paper combined with the finite element model of plate and beam to solve analytical challenges. Determine the dynamic load impact factor, the finite element analysis of the double-beam crane box-type structure of main beam, on the basis of the above, and the main beam finite element computer simulation reinforcement of the four program design and to compare. The strength of the best programs 38.7% higher than the original beam and stiffness 33.9% higher than the original beam.
Product model and Application
1. QD model 5-50/10t overhead crane with hook is mainly composed of bridge, running gear of crane, trolley and electrical device,
etc. It is divided into two working classes: A5 and A6 according to the use grade and load-up condition.
2. There are three kinds of method for entering the platform of cab: from the side, from the end and from the top. The figure is the
side entrance; arrowhead Ashows the end entrance; the top entrance is at the place there is no door.
3. The figure shows that the cab is mounted at the left end.
4. Safe slide wire or angle iron can be used for electric conduction of the crane; it can be either at the opposite side of the cab (same
as the figure) or at the sameside of the cab.
5. Operation of the crane shall be finished in the cab completely.
6. Ho is the in creased height of buffer of the crane, H0≤250.
contact email:sales66@chn-crane.com
Contact Information
-
SMF Heavy Industry (Suzhou) Co., Ltd.
-
China
-
Miller Erin