Electronic Potting Silicone Rubber
Post Message
-
Electronic Potting Silicone Rubber
-
2015-08-05
-
Chemical, Plastic, Rubber & Environmental Conservation
-
Rubber - relative Selling Leads or Buying Leads
-
China
-
Offer to sell
-
Feature : HY-9055 silicone rubber is a kind of low viscosity, Inherent flame resistance, two components addition cured potting silicone with heat-conducting. It cures with both on room temperature and heated temperature. It has the feature of the higher temperature the faster of the curing time.
Application :
It can be applied to electronic components for insulation, waterproofing, fixed and flame retardant. It mainly applied in electronic components surface with materials of PC(Poly-carbonate),PP、ABS,PVC, etc. and metal materials.
Meanwhile, HY-9055 electronic potting silicone rubber could be applied to
- high powered electronics,
- DC/DC module and circuit board which requires heat dissipation and high temperature resistance.
-It can be broadly used for LED screen, Wind Power Generator, PCB substrate, etc.
Guideline:
a, Pls put part A and part B in separate container and stir evenly before mixing the two part together.
b, Mixing Ratio: part A: part B = 1:1
c, Deaeration the mixture in vacuum pump under 0.08 MPa for 3-5 minutes.Then the mixture could be used for pouring.
Note: The thickness of the silicone affects the curing time. If the silicone used is a little thick,then the curing time will be a little longer.The temperature also affects the curing time.When in lower temperature, we suggest customers appropriately heat the mixture to accelerate vulcanization. With temperature of the degree of 80~100, the silicone will cure in 15 minutes; while in the degree of 25room temperature, the silicone will cure around 8 hours.
More information about it, pls feel free to contact my e-mail: hyyb@szrl.net or phone: 18938867609 or Tel: 0755-89311987
Contact Information
-
Shenzhen Hong Ye Jie Technology Co. Ltd.
-
China
-
Candy Wang