rubber two roll mill
Post Message
-
rubber two roll mill
-
2014-02-24
-
Chemical, Plastic, Rubber & Environmental Conservation
-
Rubber - relative Selling Leads or Buying Leads
-
ot
-
Offer to sell
-
Features of mixing mill
1. Roller: The roll is made of alloy chilled cast iron ,so the surface is hard and wearable
2. Overload: This banbury open mixing mill has overload protection devices
3 Emergency stop: .Perfect emergency stop device can ensure the safety of personnel and equipment.
4 Stock pan: tock pan is easy to clean up with dislodging device.
5. Gear box: The transmission system adopts higher hard tooth reducer, has compact structure,low noise and high efficiency.
6 Easy Operate:.Human nature designed operating system reduces labor intensity.
7, Cooling system: circulation of steam and cooling water can be through rollers to control the temperature
8, Safe electrical part: All electrical connections are safe:short circuit is not possible by any means
3.Advantage of mixing mill
1)Gap Adjustment Mode:
Manual or Electrical (by motor)
2)Lubricating method:
Manual or Auto;Grease or Thin oil
3)Emergency stop device:
Pull Rod and Emergency button
4)Roller bearings:
Nylon Bushing or Copper Sleeve or Spherical Roller Bearing
4,Purpose:
mainly works for thermal refining, sheeting,plasticating and mixing of the rubber;it is the most widely-used equipment for production of rubber products.
5,Working Principle:
the Glue Stock on the two rollers rotating reversely with different linear speed is pulled in the nip of the two rollers by the frictional force,with the reduction of the friction surface through the rollers,it is cut and extruded strongly;in the mean time,the chain scission and oxidation occurs under a certain temperature condition,increasing its plasticity,the aim of milling achieve...
Contact Information
-
DALIAN D&T RUBBER&PLASTIC MACHINERY CO., LTD
-
ot
-
Joy Lee